What's On Your Workbench for February 2022

[TexaS]

I printed out Henry's 17th century Gilded Sail wrecks in their original 1/600 scale to see what they looked like. I think you could do the same thing to our period ships by just slicing a portion of the hull below the plate line in various configurations.

Sadly the software is too “intelligent” and lifts any model that have any part below the plate and with that you instead get a failed print.

Also, I can’t see the last picture you posted. It’s disappeared like before.

[Volunteer]

Sadly the software is too “intelligent” and lifts any model that have any part below the plate and with that you instead get a failed print.

Also, I can’t see the last picture you posted. It’s disappeared like before.

I am using Cura 14.0.1 Jonas and it allows me to 'sink' any part of the model below the plate line. I have used the feature a lot to reduce or get rid of the bulky bases on some of the ironclads and ancient ships I print.

Both of my photos have disappeared it seems this morning Jonas. Here they are again